Turn the lever clockwise to the angle of 90°, pull up the lever.
Put in the new floss roll as shown and set in the main body.
NOTE : Whenever you want to take out or put in the lever only with the angle of 90°.
Press down the lever to the bottom, turn the lever clockwise to the angle of 180°, and pull out the floss from point A.
Turn the lever clockwise to the angle of 270°around until it stops, and
tauten the floss through notch B.
Hold the floss tightly in notch B, turn the lever counter-clockwise back to
its original position, pull up the floss and cut excess floss with the
recessed blade C.
Step1
Step2
Step3
Step4
Instruction of Simple Replacement
Step1
Step2
Move the lever clockwise to the angle of 180°and pull out the new floss from point A
Turn the lever clockwise to the angle of 270°around until it stops, and tauten the new floss through notch B.
Step3
Step4
Hold the floss tightly in notch B, turn the lever counter-clockwise back to its original position.
Pull up the floss and cut excess floss with the recessed blade C.
Instrucion of Clean Dental Floss
Clean the head part with tooth brush and clean water then dry up with tissue paper.
Replace new floss ribbon and put on the covers.
Quick Navigator Menu: (Right-Click again to close this menu.)
